Kenwood TK-270G Radio User Manual


 
5
Installing the Belt Clip
If necessary, attach the belt
clip using the two supplied
3 x 8 mm screws.
Note:
If the belt clip is not installed,
its mounting location may get hot
during continuous transmission or
when left sitting in a hot
environment.
If you are not using an
optional speaker/
microphone, install the
cover over the SP/MIC
jacks using the supplied
3 x 6 mm screw.
Installing the Cap over the Speaker/ Microphone Jacks
Installing the Optional Speaker/ Microphone
1 Insert the speaker/
microphone plugs into
the SP/MIC jacks.
2 Install the speaker/
microphone locking
bracket over the plugs
using the supplied
3 x 6 mm screw.