Filter
Top Products
19
■ Transmitting
1 Press and hold the PTT switch.
2 Enter the code of the transceiver you want to call
or enter a Group code on the keypad.
• If desired, you can send codes the same way you
make DTMF calls {page 15}. Both manual methods
can be used or you can store codes in memory,
then dial them from a memory location.
• “CALL” appears on the display and the LED
indicator lights red.
3 Use the transceiver the same as in a regular call;
press the PTT switch to transmit and release it to
receive.
• The called transceiver’s squelch will turn OFF while
you are transmitting. After you stop transmitting,
the squelch will turn back ON after a pre-set time
period elapses. This time period is programmed by
your dealer.
• When you release the PTT switch, squelch turns
OFF and the LED indicator flashes orange. When
you receive a signal, the LED indicator lights green.
When the signal drops out, the LED indicator
flashes orange again. If no signal is received for a
pre-determined time, squelch turns back ON.
• Pressing the key programmed as Monitor or
Squelch at any time will turn the squelch back ON.