Filter
Top Products
6
EN
System connection (continued)
Connecting other components
headphones
Plug the optional headphones equipped
with stereo mini-plugs.
÷ When listening audio through
speakers, unplug the headphones
from the PHONES jack.
In regard to demonstration
This unit incorporates a demonstration mode (display only). The demonstration shows the
display conditions of various operation modes by switching them sequentially, but the
audio does not vary during it.
When the power supply fails and restores or the power cord is unplugged and plugged
during operation, the unit automatically enters the demonstration mode ("DEMO ON").
To cancel demonstration mode : Press the SET/(DEMO) key while "DEMO ON" is displayed.
To enter demonstration mode : Keep on pressing the SET/(DEMO) key for more than 2 sec-
onds while the unit is ON.
AUX (auxiliary) component
An additional MD player, cassette tape or analog turntable with built-in equalizer (such as the
P-110) which are available separately can optionally be connected to the system using an
audio cable with stereo mini-plugs (option).
÷ The AUX IN terminals are input jacks. An AUX component for use in recording cannot be con-
nected to the system.
÷ When recording an AUX component, also read the instruction manual of the component.
÷ When an analog turntable is connected and located in proximity of the system, howling noise may
interfere with the system when the listening volume is increased. In this case, install the analog
turntable farther apart from the system.
÷ The input level from the AUX component can be adjusted on this system. (page 29)