Filter
Top Products
39
Using PowerTouch
How Do I Operate Devices?
Playback of the device connected to the CD2/TAPE2 MONITOR
These instructions are for operating a second CD player or tape deck
from a single-Zone installation or from Zone A. For more information
on operating devices in a multi-Zone setup, see “Chapter Three: Using
PowerTouch in Multiple Zones”.
To operate a second CD player or tape deck:
1. Touch
(HOME1) on the Quick Access menu.
2. Touch
(CD2/TAPE2 ON/OFF). The CD2/TAPE2 MONITOR
indicator on the receiver also lights up. In this condition, the device
connected to the CD2/TAPE2 inputs can be monitored.
Each touch of toggles its condition between ON and OFF.
After completing playback of the device connected to the CD2/TAPE2
MONITOR, be sure to set this condition to OFF.
3. Touch
. The commands appear for the device you connected
to this jack set and identified to PowerTouch.
4. Use the available commands as your CD player or tape deck remote.
Touch
(More) to access any customized commands you have
taught PowerTouch for this device. Touch the command to use it.
For more information on teaching commands to PowerTouch, see
“To Customize the PowerTouch Screen” on page 43 of the Connec-
tions and Setup Guide.
To select the input on the receiver, use the CD2/TAPE2 MONITOR
button inside the door. The CD2/TAPE2 MONITOR indicator lights
up when it is selected. After completion of playback, press the CD2/
TAPE2 MONITOR button again so that the CD2/TAPE2 MONITOR
indicator goes out.