Filter
Top Products
105
Troubleshooting
Receiver/Tuner
• The tuner’s receiving band (FM is selected by default)— see “Tuner”
on page 57 of this manual.
• The tuner’s frequency (87.5MHz is selected by default)— see
“Tuner” on page 57 of this manual
• The tuner’s preset memory—you will need to reset your stored
radio stations (see Chapter Two of the Connections and Setup Guide)
• The surround setting—see “What are Listen Modes?” on page 18
of this manual.
• The speaker settings—you will need to reset your speaker settings
( see Chapter Two of the Connections and Setup Guide)
Reset the cleared settings before operating the receiver again.
The sound is distorted, and the CLIP indicator on the receiver’s
front panel flashes red continually, or stays red for more than 1
second at a time.
Lower the analog input level for the source device you’re listening to.
(Setting the proper input level eliminates distortion that occurs if a source
device’s output level is too high. When this happens, the front panel CLIP
indicator will flash red continually or remain red for periods of 1 second
or longer. Occasional brief flashing of the CLIP indicator is okay).
1. Touch
(SETUP) on the Quick Access menu: