Filter
Top Products
22
INSTALLATION AND CONNECTION
Under certain circumstances, problems can arise when the units are connected to different connecting
sockets or circuits/earth potentials. If no others are available, it is recommended that you connect the
connecting sockets for receiver and TV set to the same cable, as shown in Figure “G”. The current rating of
the circuit used must be checked with respect to the intended application.
Further information on operating the UFS 740sw receiver can be found in the operating manual
supplied with the unit.
Only for connection in a motor home, not in a caravan!
• The green connecting cable, marked “IGNITION” allows you the option of connection to a circuit
in the vehicle that is activated when the ignition key is turned and then carries a continuous 12 V
supply. This type of connection ensures that when the engine is started the antenna is automatically
lowered into the park position (the receiver does not need to be turned on).
Note that the antenna can then be lowered only when the power supply is present in addition
to the ignition signal!
• Check the connections before you re-connect the on-board power supply.
• For commissioning and more detailed information on additional operator functions, we refer you to the
separate operating manual enclosed.
FUNCTIONAL INSTRUCTIONS FOR CONNECTION TO THE ON-BOARD POWER SUPPLY