Filter
Top Products
16
INSTALLATION AND CONNECTION
VERSION WITH EXTERNAL CABLE GLAND (FIG. F)
• The external roof gland is arranged so that it forms a water-tight enclosure on the vehicle roof
around the point where the two cables projecting from the turntable are connected to the two
extension cables within the interior of the vehicle, and where if necessary they can be disconnected.
• Arrange the cables in the cable duct when placing the turntable on to the mounting plate. Make sure
that the cables are not crossed over and that they are taut so that they cannot be crushed. Do not
try to pull the cables from the unit. This could damage the cables or loosen the cable connections.
• Place the turntable carefully on the mounting plate. The through holes on the turntable must be
perfectly aligned with the threaded holes on the mounting plate.
• Apply a little adhesive sealant to the six threaded holes in the mounting plate and screw the fastening
screws into the thread. Tighten the screws to a torque of 6 Nm.
• When feeding the cables through the HDZ 100 roof gland, make sure they are not crushed, kinked
or damaged.
*) Not supplied! The HDZ 100 roof gland is available as an accessory under part number 20410032
from specialist dealers.
Cables laid in the
cable duct*
)
and
water-tight roof gland*
)
Direction of travel