Filter
Top Products
25
or
ENTER
or
1
2
3
4
5
6
Blinks
SET
or
2 Press SET on the main unit or the remote control unit.
• If the display shows “TRACK PROTECTED”, the tracks have been protected
against accidental erasure by other component than the MD recorder in use. If you
still want to erase the tracks, go to step 3. If you will not erase them, press EDIT on
the main unit or the TITLE/EDIT on the remote control unit.
3 Press ENTER on the main unit or the remote control unit.
The change made above is entered temporarily in the memory. The display shows
“EDITING” and the TOC indicator lights up.
4 Press 0 on the main unit or the remote control unit to
eject the MD.
The data in the memory is written in the MD before it is ejected.
The display shows “UTOCwriting” during MD writing operation.
• Be careful not to apply impact to the MD recorder during writing data in the
memory in the MD. Otherwise the recording may be unplayable later.
• The data in the memory is written in the MD also when the unit is switched to
Standby mode while “EDITING” is being displayed.
To exit editing:
Press EDIT on the main unit or the TITLE/EDIT on the remote control unit before pressing
ENTER in step 3. Then, press the same button repeatedly until the editing track number is
displayed.
Caution
• Once erased, the tracks can never be restored. An MD
containing recording that you do not want to erase should
be protected by sliding the protect tab (see page 36).
XM-228BK(B)-Eng. p.17-29 98.9.25, 4:23 PM25