Filter
Top Products
10
Switching the displayed information
The display can show the disc title, track title and remaining time (recording time available
when a recordable MD is loaded) information.
When no track is selected (In Stop mode):
Press DISPLAY/CHARACTER on the main unit or the remote control unit.
Each press of the button switches the displayed information as follows.
• A disc title composed of more than 11 characters is scrolled, and the
first 11 characters are displayed after scrolling.
• The display shows “NO TITLE” if the disc has no title assigned to it.
When a track has already been selected (During
playback or in Stop mode):
Press DISPLAY/CHARACTER on the main unit or the remote control unit.
Each press of the button switches the displayed information as follows.
• A track title composed of more than 11 characters is scrolled, and the
first 11 characters are displayed after scrolling.
• The display shows “NO TITLE” if the track has no title assigned to it.
Program playback
You can program up to 32 tracks in any desired order including the same tracks.
• You can only make a program in Stop mode.
1 Load an MD.
See “Normal playback ” on page 8.
2 Select Program mode.
Main unit:
Press PLAY MODE until “PROGRAM” is shown. Then, the PROGRAM indicator
lights up.
Each time PLAY MODE is pressed, the play mode indicators switches as follows:
Remote control unit:
Press PROGRAM. The “PROGRAM” is shown and the PROGRAM indicator lights
up.
To exit Program mode, press PROGRAM once again. Then, the PROGRAM indicator
goes out.
The display shows the following for programming.
Disc title
Number of tracks and
remaining recording time
Number of tracks and
total playing time
Track No. and its playing time
Track title
PROGRAM RANDOM Off (Continuous play)
DISPLAY
/CHARA
or
Number of tracks and total
playing time
Number of tracks and remaining
recording time
Disc title
PROGRAM
The first track
XM-228BK(B)-Eng. p.1-16 98.9.25, 4:20 PM10