Filter
Top Products
15
3 Select the input by pressing INPUT SELECTOR on the
main unit.
Each press of INPUT SELECTOR switches the inputs as follows.
DIGITAL 1 IN: Select this to record the digital input from the digital source
component connected to the DIGITAL IN 1 optical jack.
The DIGITAL 1 indicator lights up.
DIGITAL 2 IN: Select this to record the digital input from the digital source
component connected to the DIGITAL IN 2 optical jack.
The DIGITAL 2 indicator lights up.
ANALOG IN : Select this to record the analog input from the analog source
component (cassette deck, tuner, etc.) connected to the ANALOG IN
(REC jacks).
4 Play the source to be recorded.
The level indicators show the input levels.
• The input level should be adjusted when the analog input is recorded (see “To adjust
the analog input level” below).
• The input level for the digital inputs does not need adjustment.
• When DIGITAL 1 or DIGITAL 2 is selected, one of the sampling frequency
indicators lights up. For example, 44.1kHz indicator is displayed for a CD player
input.
However, if no source component is connected
to the digital input or the sampling frequency
input is other than 32 kHz, 44.1 kHz, or 48 kHz,
“DIGITAL IN UNLOCK” scrolls on the display
showing that the recording is impossible.
5 Press 6 on the main unit or 3 on the remote control unit.
Recording starts.
The 3 indicator lights up.
• When the MD becomes full, “UTOCwriting” is displayed indicating that the
recording is successfully completed. Then, the MD stops. The disc indicator lights
in green.
To stop recording:
Press 7 on the main unit or the remote control unit.
“UTOCwriting” is displayed and the MD stops. The disc indicator lights in green.
To pause the MD:
Press ¶ REC PAUSE on the main unit or the remote control unit.
To resume recording, press 6 on the main unit or 3 on the remote control unit.
To adjust the analog input level ——————————
The input level should be adjusted before recording the analog input.
1 In Rec/Pause mode, start playing the source for level adjustment.
The level indicators show the input levels.
2 Turn the jog dial on the main unit to the right or left or press 4 or ¢ on the remote
control unit to increase or decrease the recording level.
As you adjust the recording level, “VOL. –10” will appear, for example. You can adjust
the recording level between VOL.–50 and VOL.0 (–50 dB and 0 dB), or to VOL. – – –
(below –50 dB).
DIGITAL 1 IN DIGITAL 2 IN ANALOG IN
DIGITAL 1
44.1kHz
or
or
REC PAUSE
or
or
L
40 30 20 15 10 6 3 0 dB
R
XM-228BK(B)-Eng. p.1-16 98.9.25, 4:20 PM15