Filter
Top Products
16
• Normally the input level should be adjusted so that the segments for 0 dB blink at the
peak level.
• When the input level is too high, the OVER indicator will light up, resulting in distorted
recording.
To display the remaining recording time ——————
In Rec/Pause or during recording, press DISPLAY/CHARACTER on the main unit or the
remote control unit.
Each press of the button switches the elapsed recording time display and remaining
recording time display alternately.
Track marking ———————————————————
The track numbers on the MD are marked at the beginning of each track. The track numbers
are identified by these “track markings” and each section between two track markings are
considered as a track.
For analog input:
You can create the track marking automatically or manually.
Automatic track marking:
Press TRACK MARKING on the remote control unit to select
“AUTO”.
• A track marking is automatically recorded every time a blank of more than 3
seconds is detected.
Manual track marking:
1 Press TRACK MARKING on the remote control unit to
select “MANUAL”.
2 When the point you want to record a track marking comes during recording, press
SET on the remote control unit.
This operation records a track marking at the point where the button is pressed.
For digital input:
When tracks are recorded from a CD player by digital input, track markings are recorded
automatically at the points where the CD tracks change.
remaining recording time
DISPLAY
/CHARA
or
TRACK
MARKING
TRACK
MARKING
SET
XM-228BK(B)-Eng. p.1-16 98.9.25, 4:20 PM16