Filter
Top Products
24
Using the numeric keys:
Select the track number with the numeric keys on the remote control unit. The selected
track is repeatedly played.
Then press SET on the remote control unit.
To select a track, see “Selecting a track with the numeric keys” on page 9.
• If you selected a wrong track number, press 7STOP/CANCEL on the main unit or
CANCEL on the remote control unit and select the correct track number.
• If the display shows “TRACK PROTECTED”, the selected track has been
protected against accidental erasure by other component than the MD recorder in
use. If you still want to erase the track, go to step 4. If you will not erase it, press
EDIT on the main unit or the TITLE/EDIT on the remote control unit.
4 Press ENTER on the main unit or the remote control unit.
The change made above is entered
temporarily in the memory. The
display shows “EDITING” and the
TOC indicator lights up.
5 Press 0 on the main unit or the remote control unit to
eject the MD.
The data in the memory is written in the MD before it is ejected.
The display shows “UTOCwriting” during MD writing operation.
• Be careful not to apply impact to the MD recorder during writing data in the
memory in the MD. Otherwise the recording may be unplayable later.
• The data in the memory is written in the MD also when the unit is switched to
Standby mode while “EDITING” is being displayed.
To exit editing:
Press EDIT on the main unit or the TITLE/EDIT on the remote control unit before pressing
ENTER in step 4. Then, press the same button repeatedly until the editing track number is
displayed.
Caution
• Once erased, the track can never be restored. An MD
containing recording that you do not want to erase should
be protected by sliding the protect tab (see page 36).
Erasing all tracks in an MD
(ALL ERASE)
The data recorded in an MD can be erased entirely to turn the MD into a blank disc.
1 Press EDIT on the main unit or the TITLE/EDIT on the
remote control unit to select “ALL ERASE”.
The ALL ERASE indicator lights up.
Each press of the button switches the editing functions as follows.
• When TITLE/EDIT on the remote control unit is used, the disc title is displayed
after “ALL ERASE”.
SET
1
2
3
4
5
6
Blinks
or
TITLE
/EDIT
DIVIDE JOIN MOVE
MD total playing time display (Disc title)
ERASE
ALL ERASE
Decrements by 1
1
2
3
4
5
or
ENTER
or
XM-228BK(B)-Eng. p.17-29 98.9.25, 4:23 PM24