Filter
Top Products
14
1
Turn On the Power
Press STANDBY/ON AUDIO (or
STANDBY/ON
on the front panel).
The STANDBY lamp goes off and the
illumination lamp lights up on the center unit.
The source indication selected previously appears
on the display.
2
Select the Band
From the remote control:
Press FM/AM.
The last received station of the selected band is tuned into.
• Each time you press the button, the band alternates
between FM and AM.
On the front panel:
Press SOURCE repeatedly until the desired band (FM
or AM) appears on the display.
The last received station of the selected band is tuned into.
• Each time you press the button, the source changes as
follows:
* “WAIT” appears on the display.
3
Adjust the Volume
To increase the volume, press and hold VOLUME +.
To decrease the volume, press and hold VOLUME –.
CAUTION:
Always set the volume to the minimum before starting any source. If
the volume is set at its high level, the sudden blast of sound energy
can permanently damage your hearing and/or ruin your speakers.
Notes:
• By pressing VOLUME + or – repeatedly, you can adjust the volume
level step by step.
• The volume level can be adjusted within 51 steps—
“MIN (minimum),” 01 to 49, and “MAX (maximum).”
• You can turn off the sounds temporarily by pressing MUTING.
4
Tune into a Station
From the remote control:
Press and hold TUNING + or – until the station frequency starts
changing continuously on
the display.
The system starts searching
for a station.
On the front panel:
1) Press 7 so that “MANUAL” appears on the display.
2) Press and hold ¢ or 4 until the station frequency starts
changing continuously on the display.
The system starts searching for a station.
Notes:
• When a station of sufficient signal strength is tuned in, the system
stops searching, and the indicator lights up on the display.
• When an FM stereo program is received, the indicator also
lights up.
• When you press the button repeatedly, the frequency changes step
by step.
To turn off the power (into standby)
Press STANDBY/ON AUDIO (or
STANDBY/ON
on the front panel) again.
The illumination lamp goes off and the STANDBY
lamp lights up.
• A small amount of power is consumed even in
standby mode. To turn the power off completely, unplug the AC
power cord.
Basic Tuner Operations
STANDBY/ON
AUDIO
FM/AM
DVD player* AUX IN
FMAM
SOURCE
B.SEARCH F.SEARCH
VCR CHANNEL
TUNING
STANDBY/ON
AUDIO
VOLUME
For in-depth information about tuner operations, see
“Tuner Operations” on pages 44 to 49.
DISPLAY
B.SEARCH
DOWN
REW
UP
FF
F.SEARCH
RETURN
STEP
TV/VIDEO
TV VOLUME
TV CHANNEL
SUBTITLE
TOP MENU
TV
STANDBY/ON
AUDIO
VCR
VCR
CONTROL
TUNER PRESET
ENTER
VOLUME
MENU
AUDIO/
FM MODE
VCR CHANNEL
TUNING
DVD FM/AM AUX
MUTING
RDS
DISPLAY
1
STANDBY/ON
AUDIO
3
VOLUME –
3
VOLUME +
2
FM/AM
4
TUNING –
4
TUNING +
MUTING
EN10-17TH-A30R[B]ff.pm6 02.7.2, 9:49 PM14