Filter
Top Products
11
6
Activate Surround or DSP Mode
You can enjoy two kinds of surround—Digital Multichannel
Surround (Dolby Digital and DTS Digital Surround) and DSP
modes.
Digital Multichannel Surround—Dolby Digital
and DTS Digital Surround
Dolby Digital or DTS Digital Surround takes effect only when you
enjoy a disc encoded with its signals—the DOLBY DIGITAL or
DTS indicator lights up on the display.
To activate Dolby Digital or DTS Digital Surround
When a disc encoded with the Dolby Digital or DTS Digital
Surround is loaded, the system detects it and starts playing the disc
automatically with Multichannel Surround activated.
– For in-depth information about surround modes, see “Creating
Realistic Sound Fields” on pages 18 and 21.
DSP modes—THEATER, HALL, LIVE CLUB,
DANCE CLUB
DSP modes take effect only when you enjoy a disc recorded using
Linear PCM—the LINEAR PCM indicator lights up on the display.
To activate DSP modes
Press DSP MODE (or DSP on the front panel).
The DSP indicator lights up and the current DSP mode
appears on the display for a while.
• Each time you press the button, DSP mode changes as follows:
– For in-depth information about DSP modes, see “Creating
Realistic Sound Fields” on pages 19, 23, and 24.
Note:
Before activating the Surround or DSP mode, adjust the speaker
setting to bring out the best performance from this system.
For in-depth information about adjusting the speaker setting, see
“Speaker Settings” on pages 16 and 17.
7
Stop Playback
Press 7 twice.
Playback stops completely and “DVD” appears
on the display. (The DVD player goes on
working for 3 minutes after playback stops.)
• This system can memorize the end point even when you press 7
once. When you start playback again by pressing 3/8, playback
begins from where it has been stopped—Resume play.
To remove the loaded disc
Press 0.
“OPEN” appears on the display and the disc tray comes out.
To close the disc tray, press 0 again.
• If you do not press the button, the disc tray closes
automatically after 3 minutes.
To turn off the power (into standby)
Press STANDBY/ON AUDIO (or
STANDBY/ON
on the front panel).
The illumination lamp goes off and the STANDBY
lamp lights up.
• If you press STANDBY/ON
AUDIO (or
STANDBY/ON
on the front panel) while the disc tray is kept
open, the disc tray closes automatically, then the system is turned
off.
• A small amount of power is consumed even in standby mode. To
turn the power off completely, unplug the AC power cord.
STANDBY/ON
AUDIO
HALLTHEATER
Normal
indication
(canceled)
LIVE CLUB
DANCE CLUB
DSP MODE
Sound signal
indicators on the
display
Sound signal
indicators on the
display
TUNER PRESET
EN10-17TH-A30R[B]ff.pm6 02.7.2, 9:49 PM11