Filter
Top Products
6
AM LOOP
FM 75
COAXIAL
AM EXT
SUB-
WOOFER
OUT
DIGITAL 1
(STB)
DIGITAL 2
(TV)
PCM/STREAM
FRONT
SPEAKERS
REAR
SPEAKERS
CENTER
SPEAKER
DIGITAL IN
ANTENNA
TAPE / CDR
AUDIO
AV IN/OUT
CAUTION:
SPEAKER
IMPEDANCE
816
AV COMPU LINK-
RIGHT
LEFT
IN
(PLAY)
OUT
(REC)
DIGITAL OUT
RGB YC
STB
TV
VCR
AV IN
FRONT
SPEAKERS
REAR
SPEAKERS
CENTER
SPEAKER
CAUTION:
SPEAKER
IMPEDANCE
816
SUB-
WOOFER
OUT
RIGHT LEFT RIGHT LEFT
RIGHT LEFT RIGHT LEFT
Connecting the Speakers
After connecting the front, center and rear speakers, and/or a
subwoofer, set the speaker setting information properly to obtain the
best possible Surround effect. For details, see page 24.
CAUTIONS:
• Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals (8 – 16 Ω).
• DO NOT connect more than one speaker to one speaker terminal.
Connecting the front, center, and rear speakers
For each speaker, connect the (+) and (–) terminals on the rear panel
to the (+) and (–) terminals marked on the speakers respectively.
1
Cut, twist and remove the insulation at the end of
each speaker cord (not supplied).
2
Press and hold the clamp of the speaker terminal
(1), then insert the speaker cord (2).
3
Release the clamp.
1
2
1
2
3
Connecting the subwoofer speaker
By connecting a subwoofer, you can enhance the bass or reproduce
the original LFE signals recorded in the digital software.
Connect the input jack of a powered subwoofer to the SUB-
WOOFER OUT jack on the rear panel, using a cable with RCA pin
plugs (not supplied).
• Refer also to the manual supplied with your subwoofer.
Note:
• You can place a subwoofer wherever you like since bass sound is
non-directional. Normally place it in front of you.
To left front speaker
To center speaker
To right front
speaker
To left rear
speaker
To right rear
speaker
SUB-
WOOFER
OUT
FRONT
SPEAKERS
REAR
SPEAKERS
CENTER
SPEAKER
CAUTION:
SPEAKER
IMPEDANCE
816
RIGHT LEFT RIGHT LEFT
Speaker Layout Diagram
Center speaker
Left rear
speaker
Right rear
speaker
Left front
speaker
Right front
speaker
Subwoofer
To obtain the best possible sound from this system, place all the
speakers except the subwoofer at the same distance from the
listening position with each speaker’s front faced toward the
listener.
Then, change the subwoofer and speaker settings to fit your
listening conditions (see page 24).
Getting Started
Powered subwoofer
(example)
EN01_10RX-DV5SL[B]2.pm5 02.8.6, 6:01 PM6