Filter
Top Products
66
Operating Other Manufacturers’ Equipment
Manufactures’ codes for STB
Manufacturer Codes
JVC 56*, 57, 67
Amstrad 43 – 49
Blaupunkt 30
Echostar 50, 51, 67
General Insrument 29
Goldstar 31
Grundig 32, 33
Hemlin/Re 01 – 05
Hirschmann 48, 52 – 55
Instrument 68
Itt/Nokia 34
Jerrold/G 06 – 14
Kathrein 52, 58 – 63
NEC 35, 36
Oak 15 – 17
Orbitech 48
Panasonic 18 – 20
Philips 37, 38
Pioneer 21, 22
RCA 65
Samsung 39, 40
Schwaiger 61, 64
Scientiff 23 – 25
Siemens 41, 42
Sony 66
Technisat 48
Tocom 26
Zenith 27, 28
7 To change the transmittable signals for
operating other manufacturers’ STB
1. Press and hold
STANDBY/ON STB.
2. Press STB.
3. Enter the manufacturer’s code
using the number buttons (1–9,
0).
See the right to find the code.
4. Release STANDBY/ON STB.
You can turn on and off the STB:
STANDBY/ON STB : Turns on or off the STB.
After pressing STB, you can perform the following operations
on an STB:
TV/STB CH + or – : Changes the channels.
1 – 9, 0, 100+ : Selects the channels.
For channel number 5, press 5.
For channel number 10, press 1, then 0.
For channel number 23, press 2, then 3.
For channel number 135, press 100+, 3,
then 5.
TV RETURN will function as the
ENTER button if your equipment
requires pressing ENTER after selecting
a channel number.
Note:
• Refer also to the manual supplied with your STB.
5. Try to operate your STB by pressing
STANDBY/ON STB.
When your STB turns on or off, you have entered the correct
code.
If there are more than one code listed for your brand of STB,
try each one until the correct one is entered.
231
564
89
7
10/0 +10
100+
EFFECT
TEST
SURR ON/OFF
SURR MODE
–
SUBWOOFER
+
CENTER
REAR·L
REAR·R
VCRSTB TV AUDIO
STANDBY/ON
VCRSTB DVD
TV DIRECT
TAPETV CDR FM/AM
*“56” is the initial JVC code.
Note:
• Manufacturers’ codes are subject to change without notice. If
they are changed, this remote control cannot operate the
equipment.
EN63-72RX-DV5SL[B]2.pm5 02.8.6, 6:02 PM66