Filter
Top Products
12
Turning Off the Sounds Temporarily
Press MUTING to mute the sound.
“MUTING” appears on the display and the volume turns off (the
VOLUME indication goes off).
• When DVD is selected as the source with your TV turned on,
“VOLUME –” appears on the TV.
To restore the sound
Press MUTING again.
• Pressing VOLUME + or – on the remote control (or turn
MASTER VOLUME on the front panel) also restores the sound.
Turning Off the Power
with the Sleep Timer
Press SLEEP repeatedly.
The SLEEP indicator lights up on the display.
• Each time you press the button, the shut-off time changes as
follows:
When the shut-off time comes
The unit is turned off automatically.
To check or change the remaining time until the shut-off time
Press SLEEP once.
The remaining time (in minutes) until the shut-off time appears.
• To change the shut-off time, press SLEEP repeatedly.
To cancel the Sleep Timer
Press SLEEP repeatedly until “SLEEP 0” appears on the display.
(The SLEEP indicator goes off.)
• Turning off the unit also cancels the Sleep Timer.
Note:
• If Sleep Timer and Auto Standby (see page 58) are used at a time,
one with the early shut-off time will turn off the unit.
Changing the Display Brightness
Press DIMMER to dim the display.
• Each time you press the button, the display and
illumination lamp dim and brighten alternately.
Activating TV Direct
You can use this unit as a DVD player and an AV selector while the
unit is not turned on. When this function is activated, the pictures
and sounds go from the video components to the TV through this
unit. In this case, you can use the video components and the TV as if
they were connected directly—TV Direct.
• This function takes effect only when the video components and
TV are connected to this unit with SCART cables.
• This function takes effect for the following sources—DVD, STB,
and VCR.
• This unit can be automatically turned on or off, and/or select the
source automatically when you set the Auto Function mode to
“AUTO1” or “AUTO2.” For details, see “Auto mode” on page 26.
To activate (or deactivate) TV Direct, follow the procedure below:
1
Press TV DIRECT.
All the indications disappear (except when DVD is selected as
the source), then the source lamp currently selected lights up.
2
Turn on the video component and TV.
3
Press one of the source selecting buttons—DVD,
STB, or VCR.
The lamp corresponding to the
selected source lights up.
To cancel TV Direct and turn off the unit, press
STANDBY/ON (or STANDBY/ON AUDIO on the remote
control).
The unit is turned off and the STANDBY lamp lights up.
To cancel TV Direct and turn on the unit, press TV DIRECT.
Notes:
• When TV Direct is activated, you cannot enjoy any of the sound
effects this unit produces, and cannot use the speakers connected
to this unit.
• You can use T-V LINK function between TV and VCR while the TV
Direct is activated.
Basic Operations
DIMMER
From the remote control ONLYFrom the remote control ONLY
DIGITAL AUTO
SPK.
L R
From the remote control ONLY
SLEEP
DIGITAL AUTO
VOLUME
SPK. SLEEP
10 20 30 60
120 901500 (off)
LR
SLEEP indicator
TV DIRECT
VCRSTB DVD
TV DIRECT
On the front panel From the remote control
MUTING
VCRSTBDVD
Ex. : When DVD is selected.
EN11-14RX-DV5SL[B]2.pm5 02.8.6, 6:01 PM12