Filter
Top Products
49
Operating external devices using the remote control
5 Release [DBS/VCR F].
NOTE
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
• Manufacturer codes are subject to change with-
out notice. You may not be able to operate the
VCR produced by the manufacturer.
• After replacing the batteries of the remote con-
trol, set the manufacturer code again.
Before the VCR operation, select the remote con-
trol mode for the VCR.
■ IMPORTANT
• Slide the remote control mode
selector to the lowest position.
1 Press [VCR].
2 Operate the remote control by
pointing it at the VCR.
NOTE
• When the remote control mode selector is slid to
the lowest position and [VCR] is pressed, some
buttons may not work.
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
Remote control button Usage
[DBS/VCR F] Turns on/off the VCR.
[CH +/
–
] Changes channels.
Number buttons
(1-10, 0, 10)
Selects the channels.
3 (playback) Starts playback.
7 Stops playback.
8 Pauses playback.
¡ Fast-forwards the tape.
1 Fast-rewinds the tape.
[REC] + 3 (playback) Starts recording.
[REC] + 8 Pauses recording.
Using the remote control for the
VCR operation
Operating external devices using the remote control (continued)
For the locations of the remote
control buttons, refer to page 46.
TH-F3[J_C]-09.fm Page 49 Monday, March 17, 2008 1:48 PM