Filter
Top Products
46
Operating external devices using the remote control
You can operate your TV, digital broadcast satellite
(DBS) and video cassette recorder (VCR) using
the remote control of this system.
*
For the number button usage, refer to “Using the
number buttons” on page 11.
■ IMPORTANT
• Slide the remote control mode
selector to the lowest position.
1 Press [TV].
2 Hold down [TV F].
• Hold down [TV F] until you finish step 5.
3 Press [ENTER] and release.
4 Press number buttons to enter the
manufacturer code.
Examples:
For a Hitachi TV: Press [1], then [0].
For a Toshiba TV: Press [0], then [8].
When the manufacturer of your TV has 2 or more
codes, select the manufacturer codes in turn and
find the one that operates the TV and the remote
control properly.
The initial code setting is “01 (JVC)”.
5 Release [TV F].
NOTE
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
• Manufacturer codes are subject to change with-
out notice. You may not be able to operate the
TV produced by the manufacturer.
• After replacing the batteries of the remote con-
trol, set the manufacturer code again.
Number
buttons
*
/
TV RETURN/
100+
Remote control
mode selector
3 (playback)
Operating a TV using the
remote control
Manufacturer Code
JVC 01
Hitachi 10
Magnavox 02
Mitsubishi 03
Panasonic 04, 11
Philips 15
RCA 05
Samsung 12, 18, 19, 20, 21
Sanyo 13, 14
Sharp 06, 16, 17
Sony 07
Toshiba 08
Zenith 09
Setting the manufacturer code
Operating external devices using the remote control
TH-F3[J_C].book Page 46 Monday, March 17, 2008 11:45 AM