Filter
Top Products
17
Playing back sources from external devices
■ IMPORTANT
• Slide the remote control mode
selector to [AUDIO].
1 Press [AUDIO IN/DIGITAL IN].
• Each time you press [AUDIO IN/DIGITAL
IN], the display changes to “AUDIO IN” or
“DGTL IN” in the display window.
• “AUDIO IN” is for selecting the device con-
nected to the [AUDIO IN] terminals.
• “DGTL IN” is for selecting the device con-
nected to the [DIGITAL IN] terminal.
• You can also select the connected device as
the source by repeatedly pressing
[SOURCE] on the main unit.
2 Start playback on the connected
device.
3 Adjust the volume or the sound
quality for your preference.
• Refer to page 12.
NOTE
• Refer also to the operation manual for the con-
nected device.
• You can also operate your digital broadcast sat-
ellite and video cassette recorder using the
remote control of this system. Refer to pages
47-49.
You can select the gain of the signal from the
[AUDIO IN] terminals. Use the initial settings for
normal operation. If the sound is too small or too
loud, change the settings.
1 Press [AUDIO IN/DIGITAL IN]
repeatedly to select “AUDIO IN” in
the display window.
2 Hold down [ENTER].
• “LEVEL 1” or “LEVEL 2” appears in the dis-
play window.
3 Press [ENTER] repeatedly to
select “LEVEL 1” or “LEVEL 2”.
• Each time you press [ENTER], the display
toggles between “LEVEL 1” and “LEVEL 2”.
• The signal gain in “LEVEL 1” is lower than
that in “LEVEL 2”.
• The display returns to “AUDIO IN” in approx-
imately 5 seconds.
Remote control
mode selector
Playing back sources from
external devices
Selecting the signal gain
Playing back sources from external devices
TH-F3[J_C]-06.fm Page 17 Friday, March 21, 2008 11:40 AM