Filter
Top Products
48
Operating external devices using the remote control
Before the DBS operation, select the remote con-
trol mode for the DBS.
■ IMPORTANT
• Slide the remote control mode
selector to the lowest position.
1 Press [DBS].
2 Operate the remote control by
pointing it at the DBS.
NOTE
• When the remote control mode selector is slid to
the lowest position and [DBS] is pressed, some
buttons may not work.
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
■ IMPORTANT
• Slide the remote control mode
selector to the lowest position.
1 Press [VCR].
2 Hold down [DBS/VCR F].
• Hold down [DBS/VCR F] until you finish
step 5.
3 Press [ENTER] and release.
4 Press number buttons to enter the
manufacturer code.
Examples:
For a Hitachi VCR: Press [0], then [4].
For a Mitsubishi VCR: Press [1], then [3].
When the manufacturer of your VCR has 2 or more
codes, select the manufacturer codes in turn and
find the one that operates the VCR and the remote
control properly.
The initial code setting is “01 (JVC)”.
(Continued on the next page)
Remote control button Usage
[DBS/VCR F] Turns on/off the DBS.
[CH +/
–
] Changes channels.
Number buttons (1-9, 0,
10)
Selects the channels.
Using the remote control for the
DBS operation
Operating a VCR using the
remote control
Manufacturer Code
JVC 01, 02, 03
Emerson 11, 26
Fisher 29
Funai 10, 14, 15, 16
Gold Star 12
Hitachi 04
Mitsubishi 13
NEC 25
Panasonic 07, 17
Philips 09
RCA
05, 06
Samsung 24
Sanyo 21, 22, 23
Sharp 27, 28
Shintom 30
Sony 18, 19, 20
Zenith 08
Setting the manufacturer code
For the locations of the remote
control buttons, refer to page 46.
TH-F3[J_C].book Page 48 Monday, March 17, 2008 11:45 AM