Filter
Top Products
47
❏ Changing the transmittable signals for operating
a VCR
Set the mode selector to “AUDIO/TV/VCR/STB.”
1
Press and hold VCR .
2
Press VCR.
3
Enter the manufacturer’s code using buttons
1 – 9, and 0.
See “Manufacturers’ codes for VCR” on the right.
4
Release VCR .
Now, you can perform the following operation on the VCR.
VCR : Turn on or off the VCR.
After pressing VCR, you can perform the following operations
on the VCR.
CHANNEL +/–: Change the channel numbers on the
VCR.
1 – 9, 0: Select the channel numbers on the VCR.
3: Start playback.
7: Stop playback.
8: Pause playback.
¡: Fast-wind a tape.
1: Rewind a tape.
See the instructions supplied with the VCR for details.
5
Try to operate your VCR by pressing VCR .
When your VCR turns on or off, you have entered the correct
code.
If more than one code is listed for your brand of VCR, try each
one until the correct one is entered.
Manufacturers’ codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
Manufacturer Codes
JVC 01, 02
Akai 02, 37
Bell+Howell 04, 17
Blaupunkt 05
CGM 04, 06, 17
Daewoo 35
Digtal 06
Fisher 04, 17
G.E. 07
Grundig 08
Hitachi 09, 10
Loewe 06, 11, 12
Magnavox 05, 06
Mitsubishi 13 – 16
Nokia 17
Nordmende 18 – 20, 32
Orion 21
Panasonic 22
Philips 06, 23
Phonola 06
Saba 18 – 20, 24, 32
Samsung 25, 26
Sanyo 04, 17
Sharp 27, 28
Siemens 08
Sony 29 – 31, 36
Telefunken 18 – 20, 32, 33
Toshiba 34
Initial setting: 01
Manufacturers’ codes for VCR
EN44-48RXF31S[B]f.p65 05.4.14, 20:0347