Filter
Top Products
14
ENGLISH
Changing the display pattern
By pressing DISP (D), you can change the
information shown on the display.
Each time you press the button, the
display patterns change as follows:
• Initial display pattern:
• Programme station (PS) name is
emphasized:
Selecting a preset station using the
preset station list
If you forget what stations are stored in what
preset numbers, you can check the preset station
list, then select your desired station on the list.
1
Select the band (FM1 – 3, AM).
1 Press SRC (source)
repeatedly to select the tuner.
2 Press and hold SRC for more
than 1 second.
3 Within about 5 seconds, press
SRC again.
Each time you press the
button, the band changes.
2
Press and hold 5 (up) or ∞ (down) until
the preset station list for the current
band (FM1, FM2, FM3, or AM) appears
on the display.
The currently received station will
be highlighted on the display.
Notes:
• If one of FM band preset station lists (FM1,
FM2, or FM3) is shown on the display, you
can show the other lists by pressing 5 (up) or
∞ (down).
• If a preset station is an FM RDS station with
PS signal, PS name will be shown instead of
the station frequency.
3
Select the number (1 – 6) for the preset
station you want.
SRC
FM1
FM2FM3
AM
345621
D
DISP
*
1
“No Name” always appears for AM or FM non-RDS
stations (see the following pages).
*
2
Appears only when selecting a preset station.
*
3
PTY code appears only when receiving an RDS
station.
*
2
*
1
*
3
EN10-14SH9101[E_EX]f.p65 03.2.27, 22:5114