Filter
Top Products
13
ENGLISH
Manual preset
You can preset up to 6 stations in each band (FM1,
FM2, FM3 and AM) manually.
Ex.: Storing an FM station of 92.5 MHz into the
preset number 1 of the FM1 band.
1
Select the band (FM1 – 3, AM) you
want to store stations into (in this
example, FM1).
1 Press SRC (source)
repeatedly to select the tuner.
2 Press and hold SRC for more
than 1 second.
3 Within about 5 seconds, press
SRC again.
Each time you press the
button, the band changes.
2
Tune in to a station (in this example,
of 92.5 MHz).
3
Press and hold the number button (in
this example, 1) for more than 2
seconds.
The selected preset number
flashes for a while.
4
Repeat the above procedure to store
other stations into other preset
numbers.
Press ¢ to tune in to
stations of higher
frequencies.
Press 4 to tune in to
stations of lower frequencies.
SRC
1
FM1
FM2FM3
AM
SRC
FM1
FM2FM3
AM
345621
Notes:
• A previously preset station is erased when a new
station is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example,
during battery replacement). If this occurs, preset
the stations again.
Tuning in to a preset station
You can easily tune in to a preset station.
Remember that you must store stations first. If you
have not stored them yet, see “Storing stations in
memory” on pages 12 and 13.
Selecting a preset station directly
1
Select the band (FM1 – 3, AM).
1 Press SRC (source)
repeatedly to select the tuner.
2 Press and hold SRC for more
than 1 second.
The band indication on the
display starts flashing.
3 Within about 5 seconds (while
the band indication is
flashing), press SRC again.
Each time you press the
button, the band changes.
2
Select the number (1 – 6) for the preset
station you want.
EN10-14SH9101[E_EX]f.p65 03.2.27, 22:5113