Filter
Top Products
– 18 –
Tuning into a Station
1
Press SOURCE repeatedly until FM or AM (MW/
LW) is selected.
The unit automatically turns on and tunes into the
previously received station (either FM or AM—MW/
LW).
• Each time you press the button, the source changes as
follows:
2
Tune into a station.
On the remote control:
Press and hold ¡ / ¢ or 4 / 1 until the
station frequencies start changing in the main
display.
On the unit:
Press and hold ¢ or 4 until the station
frequencies start changing in the main display.
• ¡ / ¢ (¢): to increase the frequencies.
• 4 / 1 (4): to decrease the frequencies.
The unit starts searching stations and stops when a
station of sufficient signal strength is tuned in.
• If an FM stereo program is received, the STEREO
indicator lights on the display.
To stop during searching, press the same button you have
pressed in step 2 above.
When you press the button briefly and repeatedly in
step 2
The frequency changes step by step.
To change the FM reception mode
On the remote control ONLY:
When an FM stereo broadcast is hard to receive or noisy,
press FM/PLAY MODE so that “MONO” appears in the
main display.
The MONO indicator also lights on the display. Reception
improves.
To restore the stereo effect, press FM/PLAY MODE again
so that “AUTO” appears in the main display.
In this stereo mode, you can hear stereo sounds when a
program is broadcast in stereo.
Presetting Stations
You can preset 30 FM and 15 AM (MW/LW) stations—
using either automatic presetting method or manual
presetting method.
• You cannot store FM reception mode separately for each
preset station.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
To preset stations automatically—Automatic Presetting
You need to preset stations separately for the FM and AM
bands.
On the remote control ONLY:
1
Press SOURCE repeatedly until FM or AM (MW/
LW) is selected.
2
Press and hold AUTO PRESET for more than 4
seconds.
Automatic Presetting starts and local stations with
strong signals are searched and stored in memory
automatically.
When automatic presetting is over, the station stored in
preset number 1 is tuned in.
3
Repeat steps 1 and 2 to store stations of the other
band—FM or AM (MW/LW).
When you cannot store stations you want
automatically
Stations with weak signals cannot be detected with this automatic
presetting method. To store such a station, use the manual
presetting method on page 19.
UNFINALIZE
DISC
SLEEP
RDS
EON
[
TA
News
Info
]
d
B
REC
LEVEL
PITCH
MONO
UNFINALIZE
DISC
UNFINALIZE
DISC
SLEEP
RDS
EON
[
TA
News
Info
]
d
B
REC
LEVEL
PITCH
UNFINALIZE
DISC
UNFINALIZE
DISC
SLEEP
RDS
EON
[
TA
News
Info
]
d
B
REC
LEVEL
PITCH
STEREO
UNFINALIZE
DISC
Continued
FM AM LINE
EN17-22_CA-NXCDR7R[B]_f 01.7.23, 9:59 AM18