Filter
Top Products
– 14 –
USC
S
SO
[
es o
]
d
B
PITCH
UNFINALIZE
DISC
Before operating the unit any further, first set the clock
built in this unit (see page 48).
Turning On the Power
To turn on the unit without playing, press so that the
STANDBY/ON lamp on the unit lights green, and the CDR
lamps light.
To turn off the unit (on standby), press
again so that
the STANDBY/ON lamp lights red, and the CDR lamps go
off.
• When the power is off (on standby), clock time appears
in the main display—initial setting when shipped from
the factory (see “Saving the Power Consumption while
On Standby” below).
• A little power is always consumed even while the unit is
in standby mode.
To switch off the power supply completely, unplug the
AC power cord from the AC outlet.
Saving the Power Consumption while On
Standby
You can save the power consumption while the unit is
turned off by erasing the clock display.
To save the power consumption while on standby, press
DISPLAY on the remote control while the unit is turned off
(on standby—while the STANDBY/ON lamp lights red).
• Power consumption during standby is reduced (see
“Specifications” on page 57) and the clock will not be
shown while the unit is turned off (on standby).
To cancel the power consumption saving mode, press
DISPLAY again while the unit is turned off (on standby).
When you unplug the AC power cord or if a power
failure occurs
The power consumption saving mode (“DISPLAY OFF”) will be
canceled.
UNFINALIZE
DISC
SLEEP
RDS
EON
[
TA
News
Info
]
d
B
REC
LEVEL
PITCH
UNFINALIZE
DISC
USC
S
SO
[
es o
]
d
B
PITCH
UNFINALIZE
DISC
Selecting the Sources and Starting Play
To select 3-CD Changer as the source, press CD 3 / 8.
The unit automatically turns on. (Play starts if a CD is on
the last selected disc tray.)
To stop play, press 7.
• For more detailed operations, see pages 23 to 28.
To select CD Recorder as the source, press CDR 3 / 8.
The unit automatically turns on. (Play starts if a disc is in
CD Recorder.)
To stop play, press 7.
• For more detailed operations, see pages 29 and 30.
To select the tuner and external component as the
source, press SOURCE. The unit automatically turns on.
• Each time you press the button, the source changes as
follows:
FM: To listen to an FM broadcast.
AM: To listen to an AM (MW/LW) broadcast.
LINE: To play back the external component connected
to the LINE IN jacks on the rear panel.
• For operating FM/AM (MW/LW), pages 17 to 22.
• For operating the external components, refer to its
manual.
To adjust the input level through the LINE IN jacks
If the sound from the component connected to the LINE IN
jacks is too loud or is not loud enough when changing the
source to “LINE” from another source (without adjusting
the volume level), you can change the input level through
the LINE IN jacks.
On the unit ONLY:
When the source is “LINE,” press and hold SET (inside
the sliding panel) repeatedly to select your desired level.
• Each time you press and hold the button, the input level
changes—“LEVEL 1,” “LEVEL 2,” and “LEVEL 3.”
LEVEL 1: Normally select this. (Initial setting when
shipped from the factory.)
LEVEL 2: Select this when the sound is not loud
enough.
LEVEL 3: Select this when the sound is too loud.
Continued
FM AM LINE
EN13-16_CA-NXCDR7R[B]_f 01.7.23, 9:59 AM14