– 9 –
1
2
3
4
1 If cords are covered with insulation, twist the core of
the cord at the end of each cord, then remove the
insulation.
2 Connect the AM (MW/LW) loop antenna to the AM
LOOP terminals as illustrated.
3 Turn the AM (MW/LW) loop antenna until you have
the best reception.
To connect an outdoor AM (MW/LW) antenna
When reception is poor, connect a single vinyl-covered
wire to the AM EXT terminal and extend it horizontally.
Keep the AM (MW/LW) loop antenna connected.
For better reception of both FM and AM (MW/LW)
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
AM (MW/LW) antenna
Vinyl-covered wire
(not supplied)
AM (MW/LW) loop antenna
(supplied)
Connecting Speakers
You can connect the speakers using the speaker cords.
Right
speaker
Left
speaker
1 If cords are covered with insulation, twist the core
of the cord at the end of each cord, then remove the
insulation.
2 Hold the clamp of the speaker terminal.
3 Insert the end of the speaker cord to the terminal.
Match the polarity of the speaker terminals: Red (+) to
red (+) and black (–) to black (–).
4 Release the finger from the clamp.
Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
Black
Red
Speaker
cord
Red
Black
2
3
1
EN01-12_CA-NXCDR7R[B]_f 01.7.23, 9:58 AM9