Filter
Top Products
41
AV COMPU LINK Remote Control System
The AV COMPU LINK remote control system allows you to operate JVC video components (TV, VCR, and
DVD player) through the receiver.
Notes:
• Without connecting the video
components with RCA pin plugs
as described on page 11, the AV
COMPU LINK remote control
system cannot operate the
components.
• Refer also to the manuals
supplied with your video
components.
To use this remote control system, you need to connect the video components you want
to operate, following the procedures below.
1. Connect your VCR, DVD player, and TV as follows, using the cables with the
monaural mini-plug (not supplied).
2. Connect the VCR, DVD player, and TV using the cables with RCA pin plug,
see pages 11 and 12.
If you connect the VCR or DVD player to the TV directly using an S-video
cable, leave the corresponding video input on this receiver unplugged — VCR IN
(PLAY) for the VCR or DVD for the DVD player.
3. When turning on the TV for the first time after the AV COMPU LINK
connection, turn the TV volume to the minimum using the TV volume control
on the TV.
If the AV COMPU LINK terminal on
the TV is “AV COMPU LINK EX”
If the AV COMPU LINK terminal on
the TV is “RECEIVER/AMP”
TV
DVD player
VCR
or
AV
COMPU LINK
RECEIVER/
AMP
AV
COMPU LINK
AV
COMPU LINK
VHS
AV
COMPU LINK
DVD
AV
COMPU LINK
EX
RECEIVER/AMP
(VCR)
EX
RX-664VBK(J)_0119-001B_En.24-50 98.1.6, 11:30 AM41