Filter
Top Products
40
COMPU LINK Remote Control System
The COMPU LINK remote control system allows you to operate JVC audio components through the remote
sensor on the receiver.
To use this remote control system, you need to connect JVC audio components through
the COMPU LINK-3 (SYNCHRO) jacks with the cable (monaural mini-plug supplied
with those components):
This remote control system allows you to use the four functions listed below.
Remote Control through the Remote Sensor on the Receiver
You can control JVC audio components through the remote sensor on the receiver using
this remote control. Aim the remote control directly at the remote sensor on the receiver.
For details, see page 43.
Automatic Source Selection
When you press the play (
33
33
3) button on a connected component or on its own remote
control, the receiver automatically turns on and changes the source to the component.
On the other hand, if you select a new source on the receiver or the remote control, the
selected component begins playing immediately.
In both cases, the previously selected source continues playing without sound for a few
seconds.
Automatic Power On/Off (only possible with the COMPU LINK-3
connection)
Both the CD player and cassette deck turn on and off with the receiver.
When you turn on the receiver, the CD player or cassette deck will turn on
automatically, depending on which component has been previously selected.
When you turn off the receiver, both the CD player and cassette deck will turn off.
Synchronized Recording
Synchronized recording means the cassette deck starts recording as soon as a CD (or a
record) begins playing.
To use synchronized recording, follow these steps:
1 Put a tape in the cassette deck, and a disc in the CD player (or a record on the
turntable).
2 Press the record (¶ ) button and the pause (8) button on the cassette deck at the
same time.
This puts the cassette deck into recording pause.
If you do not press the record (¶) button and pause (8) button at the same time, the
synchronized recording will not start.
3 Press the play (3) button on the CD player (or on the turntable).
The source changes on the receiver, and as soon as play starts, the cassette deck
starts recording. When the play ends, the cassette deck enters recording pause, and
stops about 4 seconds later.
Notes:
•
Without connecting the audio
components with RCA pin plugs
as described on page 11, the
COMPU LINK remote control
system cannot operate the
components.
•
Refer also to the manuals
supplied with your audio
components.
Notes:
•
During synchronized recording,
the selected source cannot be
changed.
•
If your CD player is playing in
program mode, a 4-second
blank is recorded between tracks
so that the music scan feature
of your cassette deck can be
used on the recorded tape.
•
If the power of any component
is shut off during synchronized
recording, the COMPU LINK
remote control system may not
operate properly. In this case,
you must start again from the
beginning.
CD player
Cassette deck
Turntable
COMPU LINK – 3
(SYNCHRO)
RX-664VBK(J)_0119-001B_En.24-50 98.1.6, 11:30 AM40