Filter
Top Products
34
Notes:
• No test tone comes out of the
rear speakers when you have
selected “3CHLOGIC.”
• No test tone comes out of the
center speaker when you select
“PHANTOM” for the center
mode.
5. Press Control
@@
@@
@ /
##
##
# to select the center mode.
Each time you press the button, the center modes change
as follows:
WIDE Select this mode when the center speaker can reproduce the bass
better than the front speakers. All signals of the center channel are
output through the center speaker.
NORMAL Select this mode when the center speaker cannot reproduce the
bass better than the front speakers. The bass portions of the center
channel signals are output through the front speakers.
PHANTOM Select this mode when you do not use a center speaker. The center
speaker channel signals are output through the front speakers.
6. Press Control
%%
%%
% /
fifi
fifi
fi until “–DELAY +” appears on
the display.
7. Press Control
@@
@@
@ /
##
##
# to adjust the delay time of the
rear speaker output.
Each time you press the button, the delay time changes
as follows:
DELAY 1 Select this when the distance from you to your rear speakers is
greater than that to the front speakers.
DELAY 2 Select this when the distance from you to your rear speakers is
almost equal to that to the front speakers.
DELAY 3 Select this when the distance from you to your rear speakers is less
than that to the front speakers.
8. Press Control
%%
%%
% /
fifi
fifi
fi until “TEST” appears on the
display, then press Control
@@
@@
@ /
##
##
# to start checking
the speaker output balance.
“TEST” starts flashing on the display, and a test tone
comes out of the speakers in the following order:
Notes:
• If you have already set the
center speaker size following
the procedure described on
page 19, you do not have to
select the center mode in this
procedure.
• When you have selected
“3CHLOGIC,” you cannot select
“PHANTOM.”
DELAY 1 DELAY 2 DELAY 3
Left front
speaker
Center
speaker
Rear
speakers
Right front
speaker
Continued to the next page.
WIDE
NORMAL
PHANTOM
Note:
When you have selected
“3CHLOGIC” or “THEATER,” you
cannot adjust the delay time.
RX-664VBK(J)_0119-001B_En.24-50 98.1.6, 11:29 AM34