Filter
Top Products
33
Preparing for Surround Modes
Once you have set the surround modes, you can use the same adjustments every time
you want to activate the surround mode you want. The receiver memorizes surround
adjustments for each mode.
On the front panel:
1. Press SURROUND so that the Control
%%
%%
% /
fifi
fifi
fi /
@@
@@
@ /
##
##
#
buttons work for selecting the Surround Processor
mode.
The lamp above the button lights up.
2. Press Control
%%
%%
% /
fifi
fifi
fi to select one of the surround
mode (“PROLOGIC,” “3CHLOGIC” or
“THEATER”).
Each time you press the button, the Surround Processor
modes change as follows:
PROLOGIC Select this mode when you use a center speaker and rear
speakers.
THEATER Select this mode to watch a video source with Dolby Surround
when you have connected the rear speakers (and a center
speaker). This mode gives you the feeling of a movie theater.
3CHLOGIC Select this mode when you use a center speaker without rear
speakers.
OFF Select this to turn off the Surround Processor mode.
* You cannot select the 3D-PHONIC modes or the DAP modes in this step.
For the 3D-PHONIC modes: see pages 27 and 28.
For the DAP modes: see pages 29 and 31.
3. Press ADJUST so that the Control
%%
%%
% /
fifi
fifi
fi /
@@
@@
@ /
##
##
#
buttons work for adjusting the selected surround
mode.
The lamp above the button lights up.
4. Press Control
%%
%%
% /
fifi
fifi
fi until “CNT MODE” (Center
Mode) appears on the display.
Using the Surround Processor
SURROUND
PROLOGIC THEATER
PAVILION*
3CHLOGIC
3DACTION*
OFF
Ex.
Note:
When one of the surround modes
is selected, the corresponding
indicator lights up on the display.
ADJUST
RX-664VBK(J)_0119-001B_En.24-50 98.1.6, 11:29 AM33