Filter
Top Products
29
Using the Surround Processor
Ex.
PROLOGIC THEATER
PAVILION*
3CHLOGIC
3DACTION*
OFF
(One of the five modes appears)
DANCE C
LIVE C
PAVILION
HALL
HEAD P
ADJUST
Using the DAP Modes
You can use five DAP modes — “Dance Club, Live Club, Hall, Pavilion, and
Headphones.” These modes (except “Headphones”) require the front speakers and the
rear speakers, but do not require a center speaker to enlarge the sound field.
Among the DAP modes, “Headphones” is very special. It can create the same stereo
sound as you listen through the speakers off air while listening to a source using
headphones. So, you can feel as if you were not using the headphones and listening to
music in a room.
On the front panel:
1. Press SURROUND so that the Control
%%
%%
% /
fifi
fifi
fi /
@@
@@
@ /
##
##
#
buttons work for selecting the Surround Processor
mode.
The lamp above the button lights up.
2. Press Control
%%
%%
% /
fifi
fifi
fi until one of the DAP mode
(“HEAD P,” “PAVILION,” “HALL,” “LIVE C” or
“DANCE C”) appears on the display.
Each time you press the button, the Surround Processor
modes change as follows:
* As for the 3D-PHONIC modes (see page 27) and the
DAP modes, one of the previously selected mode
appears on the display.
3. Press Control
@@
@@
@ /
##
##
# until the DAP mode you want
appears on the display.
Each time you press the button, the DAP modes change
as follows:
HEAD Phones*
Gives a spacious stereo effect when listening with headphones.
PAVILION Gives the spacious feeling of a pavilion with a high ceiling.
HALL Gives clear vocal and the feeling of a concert hall.
LIVE Club Gives the feeling of a live music club with a low ceiling.
DANCE Club Gives a throbbing bass beat.
* When you select “HEAD P,” you cannot go to the following steps. No adjustments
can be made for “Headphones.”
4. Press ADJUST so that the Control
%%
%%
% /
fifi
fifi
fi /
@@
@@
@ /
##
##
#
buttons work for adjusting the selected mode.
The lamp above the button lights up.
SURROUND
Note:
When one of the DAP modes is
selected, the DAP indicator also
lights up on the display.
Note:
When changing the DAP modes
to “PAVILION” or “HALL,” a
reverberation sound comes out.
This is because a long
reverberation is applied to these
two modes.
RX-664VBK(J)_0119-001B_En.24-50 98.1.6, 11:29 AM29