Filter
Top Products
900 MHz RTK—Original GreenStar Display
JS56696,00007FE -19-15APR10-1/1
INFO Pages, Vehicle
Screen: INFO - GPS - PAGE 5
This screen allows operator to view:
•
Status
- OK - Base Station is transmitting correction.
- No Stored Base - 24 hour self survey is required for
current location.
- Initializing - Receiver is initializing radio, acquiring
GPS signal.
- Self Survey - 24 hour self survey in progress at base
station.
- No Signal - Vehicle radio is not receiving signal from
base station.
•
Sat Corrections - Indicates number of GPS satellites
for which base station is transmitting correction.
•
Distance - Distance from base station to vehicle
receiver.
•
Direction - Direction in degrees to base station.
•
Base Battery (volts) - Base Station voltage.
•
Signal Level - Level of signal that is detected at radio.
The signal level will range from 0 to 100 (-180 dBm to -80
dBm or above). Press E button to refresh signal level.
NOTE: For Data Received (%): Value less than
100 % indicates an obstruction between base
station radio and vehicle radio.
If percent of received correction is 0, and signal
level is high, check for potential radio interference
sources such as two-way radios, radio towers, etc.
If percent of received correction is 0, and
signal level is low, check for potential
obstructions of line of sight conditions such
as hills, buildings, trees, etc.
•
Data Received (%) - Percent of received correction to
vehicle from base station.
PC12087 —UN—13MAY09
Vehicle connected to Absolute Base
A—RTK Base Station Data
Status
B—Satellite Corrections
Location Number
C—Distance
Direction
D—Base Battery
Radio Data
E—Signal Level
Data Received
F—Radio Connection
G—Software Version
Serial Number
•
Radio Connection - Indicates source of correction. If
there is no connection, this will toggle between base
and repeater.
•
SW - Version of radio software.
•
SN - Serial number of radio connected to receiver.
30-11
121511
PN=50