Filter
Top Products
900 MHz RTK—Base Station Setup
JS56696,0000808 -19-15APR10-1/1
JS56696,000080A -19-15APR10-1/1
JS56696,000080C -19-15APR10-1/1
Specic Tower Setup Information
It is recommended that the receiver be, at minimum, 9.1
m (30 ft) away from the tower to prevent both Shading
and Multipathing. This distance may vary depending on
the frame design of the tower or structure that you are
mounting it around.
When using the 91 m (300 ft) extension harness, do not
cut the harness to the length needed. This harness has
built in voltage protection and is shielded. Cutting the
harness will limit the effectiveness of the harness and will
cause failures of either the radio or the receiver due to
static electricity build up on the harness. This harness
was built to be buried underground, so it is suggested to
bury all extra harness underground to protect the harness.
After deciding what structure that you will be mounting
your base station on, there are ve different ways to set
up your base station.
•
Utilizing Both The 91 m (300 ft) RTK Extension Harness
And Low Loss Coax Cable
•
Utilizing The RTK Extension Harness
•
Utilizing A Repeater
•
Utilizing Just Low Loss Coax Cable
•
Leaving The Radio And Receiver As A Single Unit
Utilizing The RTK Extension Harness
This base station setup allows you to mount the receiver
at a secure location and mounting the radio, with antenna,
to an elevated position, and utilizing 91 m (300 ft) of
RS232 cable between the receiver and radio.
A—Radio mounted on tower
B—Base Station Receiver
PC8762 —UN—16SEP05
Utilizing Just Low Loss Coax Cable
This base station set up leaves the receiver and radio in a
secure location and using low loss coax cable running to
the antenna at an elevated position.
A—Receiver and Radio
B—Coax Cable
PC8763 —UN—16SEP05
20-15
121511
PN=23