Filter
Top Products
54
Pressing repeat disc will advance you to the next command in the table;
when you reach the end of the list, the Nº31.5 will return to the beginning.
If no button is pushed for more than ten seconds, the Nº31.5 will “time out”
and return to normal operation.
special commands table
Command Display
positive “operate” OPERATE
positive “standby” STANDBY
positive “stop w/o moving lid” STOP, NO LID
positive “display intensity to off” DISPLAY OFF
positive “display intensity to medium” DISPLAY MED
positive “leave pause” UNPAUSE
positive “enter pause” PAUSE
positive “turn off repeat” REPEAT OFF
positive “turn on index mode” INDEX ON
positive “turn off index mode” INDEX OFF
positive “open lid” OPEN LID
positive “close lid” CLOSE LID
single-button “random play” RANDOM PLAY
switch to analog-input switching mode ANALOG MODE
switch to digital-input switching mode DIGITAL MODE
4 MOMENTARILY PRESS THE DISPLAY INTENSITY BUTTON TO TRANSMIT THE
SELECTED IR CODE
Line up the IR window of your remote control with the right side of the
display of the Nº31.5, at a distance of approximately 2"-6". Select the to-be-
learned button on the remote, then fire the selected code from the Nº31.5
by pressing display intensity. The Nº31.5’s display will show sending code
during the IR transmission.
(If you are uncertain as to how to prepare your remote control for learning
new commands, refer to the instructions provided with the remote control.)
5 REPEAT THE PROCESS OF “TEACHING” NEW SPECIAL COMMANDS
UNTIL ALL DESIRED COMMANDS HAVE BEEN LEARNED BY YOUR
REMOTE CONTROL.
If you take longer than approximately ten seconds between button pushes,
the Nº31.5 will time out and return to normal operation. If this occurs, re-
turn to step #1 in this section. You may cycle through the entire list by
pressing repeat disc repeatedly.
6 WHEN FINISHED, RETURN TO NORMAL OPERATION BY ALLOWING THE
Nº31.5 TO “TIME OUT”
The Nº31.5 will “timeout” and return to normal operation after approxi-
mately ten seconds.