HP (Hewlett-Packard) N31.5 Stereo System User Manual


 
34
main power
REFERENCE CD TRANSPORT Nº 31.5
designed and manufactured in U.S.A.
by MADRIGAL
S/N
slave
out
slave
in
eiaj st spdif
aes/ebu
communication ports digital outputs
WARNING: BEFORE ATTEMPTING TO
OPERATE THIS DEVICE, REFER TO OWNER'S
MANUAL FOR PROPER OPERATING
INSTRUCTIONS AND SAFETY PRECAUTIONS.
HAZARDOUS VOLTAGE AVAILABLE INSIDE;
DISCONNECT AC ~ MAINS CABLE BEFORE
OPENING UNIT.
65 7
8
9 101 32 4
CLASS 1
LASER PRODUCT
Rear Panel
1 OPERATING VOLTAGE INDICATION
The Nº31.5 is set at the factory (internally) for 100, 120, 200, 220, or 240VAC
mains operation as appropriate for the country in which it is to be sold.
Make sure that the label on the rear of the left tower (as seen from the
rear) of the Nº31.5 indicates the correct AC operating voltage for your loca-
tion, as attempting to operate the Nº31.5 at an incorrect voltage can damage
the unit.
The Nº31.5 Reference CD Transport is also set at the factory for operation
on either 50 or 60 Hz AC line frequencies, as appropriate for the country in
which it is to be sold. It will not operate if it senses an incorrect line fre-
quency.
Warning! Neither the voltage nor the line frequency setting may be
changed by the user. There are no user serviceable parts
inside the Nº31.5. Only qualified, authorized service personnel
may open the Nº31.5 CD Transport, as hazardous voltages
exist within the unit.
2 MAIN POWER
This switch turns the Nº31.5 on and off. The switch must be in the “|” (on)
position for the Nº31.5 to function. (See Setup and Installation.)
Caution: Never operate the main power switch without first making sure
that power is turned off to your receiver, integrated amplifier,
or preamplifier/power amplifier.