HP (Hewlett-Packard) N31.5 Stereo System User Manual


 
44
Erasing a selection You also may erase a selection from a previously saved program. To erase a selec-
tion:
1. Load a CD for which you’ve already saved a program (the letter P
will appear preceding the track number on the display); or load an
unprogrammed CD, then assemble and save a program.
2. Using the next and previous (or track + and track – on the remote,
or the numbered buttons on the remote), select the track you want
to erase from your program.
3. Erase the selection to your program by pressing program – (on the
remote control, press prg/time, then press ).
Note: You must press program – (or prg/time and ) within five
seconds after making a selection, or the selection won’t be re-
corded.
4. Repeat steps 2 and 3 for each selection you want to add to your
program. Make sure to press program – (or prg/time and ) after
each selection.
5. When you’ve finished adding selections, press program save; the
display will show PROG CHANGED. This last step is what makes
your change permanent.
Temporarily overriding a
previously saved program
To override a previously saved program (temporarily), press program clear (on
the Remote Control, press the 0 numbered key, then press prg/time); the display
will show PROG CLEARED.
All of the CD’s tracks will be accessible for basic operation, but the program will
still be retained in the Nº31.5’s memory. (See Basic Operation.)
Note: If you press program save after pressing program clear, the
display will show PROG DELETED and the program will be erased
from the Nº31.5’s memory.
Erasing a program To erase a previously saved program permanently from the Nº31.5’s memory:
1. Press program clear; the display will show PROG CLEARED.
2. Press program save; the display will show PROG DELETED.
Once again, this last step of pressing program save is what makes your change
permanent (as opposed to merely overriding the program this once).