HP (Hewlett-Packard) N31.5 Stereo System User Manual


 
27
You may vary the nature of the information in this part of the display using
the display mode button. (See Front Panel.)
4 INFRARED RECEIVER AND TRANSMITTER
This part of the display accepts commands from the Nº31.5’s Remote Con-
trol. (See Remote Control.) When using the Nº31.5 to teach a learning re-
mote special commands, it can also transmit IR signals. (See Using Learning
Remote Controls.) Always keep this window clean and unobstructed.
Display messages The display also shows a variety of messages about the Nº31.5’s status and opera-
tion. Here are some of the messages you’ll see, and what they mean.
CLOSING: The Lid is in motion (closing); appears after the
Lid Open/Close button is pressed.
FIRST TRACK: The previous button was pressed while the first track
on the CD (or in a program or a random sequence) was playing.
INDEX SEARCH: The Nº31.5 is scanning the CD for indices; appears
after index mode is pressed.
INSERT DISC: The Lid is open; appears after the Lid has stopped
opening.
LAST TRACK: The next button was pressed while the last track on
the CD (or in a program) was playing.
NEW PROGRAM: A new program was recorded in the Nº31.5’s
memory; appears after program save is pressed.
NO DAMPER: The Lid is closed and the Disc Damper isn’t installed
on the spindle; appears after the Lid has closed.
NO PROGRAM: There’s no program in the Nº31.5’s memory; ap-
pears after program review or program clear is pressed.
OPENING: The Lid is in motion (opening); appears after the
Lid Open/Close button is pressed.
P01 IS 1st: Indicates a track’s place in a program; appears after
program review is pressed.
P02 02 IS 2: Indicates an index’s place in a program; appears after
program review is pressed.
PROG CHANGED: Changes to a program were recorded in the
Nº31.5’s memory; appears after program save is pressed.
POLARITY PRG: A program including only the polarity invert func-
tion was saved; appears after program save is pressed.
PROG DELETED: A previously saved program was erased from the
Nº31.5’s memory; appears after program clear is pressed, followed
by pressing program save.
PROG CLEARED: The temporary program was erased, or the previ-
ously saved program was temporarily overridden; appears after
program clear is pressed.
PROGRAM END: There are no more selections in the program be-
ing reviewed; appears after program review is pressed.
READING: The Nº31.5 is reading track and time information from
the CD; appears after the Lid has closed.