Filter
Top Products
43
Advanced Programming
After you have created a few programs as outlined in the previous section, you
may want to review them, add extra tracks to existing programs, or in other ways
change the nature of what you have done. The Nº31.5 provides great flexibility in
these regards.
Reviewing a program To review your program before playing it:
1. Load a CD for which you’ve already saved a program (the letter P
will appear preceding the track number on the display); or load an
unprogrammed CD, then assemble and save a program.
2. Press program review. The display will show the first selection in
your program. For example, if track 3 is the first selection in your
program, the display would show P03 IS 1st. If index 2 on track 5 is
the first selection, the display would show P05 02 IS 1.
Note: If you press program review when there is no program in
the Nº31.5’s memory, the display will show NO PROGRAM.
3. To view the next selection, press program review again, and so on.
Press program review for each selection in your program. After you
view the last selection, the display will show PROGRAM END.
Adding a selection
You may add a selection to the end of a previously saved program. To add a selection:
1. Load a CD for which you’ve already saved a program (the letter P
will appear preceding the track number on the display); or load an
unprogrammed CD, then assemble and save a program.
2. Using the next and previous (or the numbered buttons on the Re-
mote Control), select the track you want to add to your program.
You may also include indices in your program. Press index mode,
then use next and previous (or the numbered buttons on the Re-
mote Control) to select an index. [Note: If your Nº31.5 is linked to
a compatible Mark Levinson digital processor via the
communication ports, you may set the playback polarity indepen-
dently for each track. See Setting Options. In this case,
press the polarity invert button on the digital processor’s front
panel, or press d/a polarity on the Nº31.5’s Remote Control, before
continuing to step 3.]
3. Add the selection to your program by pressing program + (on the
Remote Control, press prg/time, then press +).
Note: You must press program + (or prg/time and +) within five
seconds after making a selection, or the selection won’t be re-
corded.
4. Repeat steps 2 and 3 for each selection you want to add to your
program. Make sure to press program + (or prg/time and +) after
each selection.
5. When you’ve finished adding selections, press program save; the
display will show PROG CHANGED. This last step is what makes
your change permanent.