Filter
Top Products
Initial Configuration 139
Initial Configuration
Configuring Audio Output
You must adjust the audio settings in two places after you
have installed and connected the HP Digital Entertainment
Center to your audio system.
Configure both the Media Center speaker settings and
audio for the DVD player.
The following table shows which procedures to perform
for your audio system. If you set up speakers using the
Media Center Optional Components wizard, then set up
the audio for the DVD player only.
Media Center
speaker
settings
(TV Audio)
DVD audio
setting Procedure
2
(default)
2 speakers;
Dolby Surround
Compatible
(default)
Default, no audio output configuration required.
5.1 5.1 Change settings. See “Configuring audio for Media Center” on
page 140 and “Configuring audio for the DVD player” on page 140.
7.1 7.1 Change settings. See “Configuring audio for Media Center” on
page 140 and “Configuring audio for the DVD player” on page 140.
Digital Audio
S/PDIF on
(default)
Digital Audio
S/PDIF off
(default)
Change settings. See “Configuring audio for the DVD player” on
page 140.
If you use digital audio, the Media Center S/PDIF default setting is on,
but the DVD Player S/PDIF default setting is OFF. You must change the
DVD S/PDIF default setting to ON to hear all channels in DVD digital
audio.