Filter
Top Products
Multiroom Operation
32
ENGLISH
The AVR80 is unique among A/V
receivers in that it is equipped to operate
as the control center for a sophisticated
multiroom operation with accessories as
simple as a remote IR sensor or as
sophisticated as a specialized external
amplifier and a special version of the
world-famous AudioAccess wall mounted
keypad controls. Although some
multiroom installations will require the
services of a specially trained installer, it
is possible for the average do it yourself
hobbyist to install a simple remote room
system. For additional information on
using the AVR80 in multiroom
installations we suggest that you contact
your dealer or custom installer.
Installation
The key to remote room operation is to
link the remote room to the AVR80’s
location with wire for an infrared receiver
and speakers or an amplifier.
IR Link
The remote room IR receiver should be
connected to the AVR80 via standard
coaxial cable. Plug the IR connection
cable into the mini jack inside the Multi
area in the middle of the AVR80’s rear
panel.œ
If other Harman Kardon compatible
source equipment is part of the main
room installation, the REMOTE
CONT. OUT jack on the rear panel ∑
should be connected to IR IN jack on the
CD player or cassette deck. This will
enable the remote room location to
control source equipment functions as
well as the remote room input and
volume.
NOTE: All remotely controlled
components must be linked together in a
daisy chain. Connect the IR OUT jack of
one unit to the IR IN of the next to
establish this chain.
Audio Link
Depending on the distance from the AVR
80 to the remote room, two options are
available.
The preferred method is to run high
quality, shielded audio interconnect cable
from the AVR80’s location to the remote
room. At the remote room, connect the
interconnect cable to a stereo power
amplifier. The amplifier will be
connected to the room’s speakers. No
volume control is required, as the AVR80
and the remote IR link will provide that
function. At the AVR80, plug the audio
interconnect cable into the MULTI OUT
jacks ® at the top left corner of the AVR
80’s rear panel.
NOTE: The remote power amplifier must
have signal sensing capability or be left
on constantly to assure automatic
operation at the remote room.
As an alternative, the amplifier may be
placed at the same location as the AVR80,
with a standard audio interconnect
between the two. Speaker wires should
then be run to the remote room. High
quality AWG-12 speaker wire is preferred.
IMPORTANT NOTE: Any cables run
inside walls should carry safety
certification that is required by the local
building and electrical codes. To avoid
interference, audio and speaker cables
should not be parallel to, or in the same
conduits with AC cables. If you have any
questions about multi-room wiring
consult your dealer, custom installer or
electrician.
Set-up
Once the equipment connections have
been made, the AVR80 needs to be
configured for multiroom operation by
following these steps:
1. Press the SELECT r to bring the
MAIN MENUto the screen (Figure #1).
Press the ¤ button q four times until
the on screen
>
cursor is pointing to
MULTI ROOM SELand press
SELECT r. The video screen
will move to the MULTI ROOM
SELECTORmenu (Figure #17).
2. Press the › button q until the
desired input source for the multi room
system is selected.
AVR80 manual 11/01/98 13:01 Side 32