Filter
Top Products
System Configuration
17
ENGLISH
6. Press SELECT r to move to the
next screen, SET UP MENU 1.
(Figure #2).
7. The first item to be set is the Center
Channel Mode. The on screen
>
cursor
will already point toward this option
when you select the menu. Press the
‹ or › buttons q to choose one of these
center channel options by moving the
cursor:
LARGE: Choose this option if you are
using either a THX Certified speaker
system with a subwoofer or large size
full range center channel speaker.
SMALL: Choose this option if the
center speaker is small sized.
NONE: Choose this option if you are
not using a center channel speaker.
8. When the center channel speaker
selection is complete, press the ¤ button
q to move to the next option. Note that
the on screen
>
cursor will move down to
SUBWOOFER.
9. Press the ‹ or › buttons q to choose
one of these options:
ON: Choose this option if a Subwoofer
is installed, getting its signal from
‘subwoofer’ jack µ .
OFF: Choose this option if no
Subwoofer is present.
10. Press ¤ q once and then SELECT
r to move to SET UP MENU 2 to
continue the set-up procedure. (Press ¤
twice and then SELECT if you prefer to
return to the MAIN MENU.)
11. At SET UP MENU 2 (Figure #3) you
are able to establish settings for
multiroom operation and lock the
control settings. You may skip these
menus by pressing ¤ q until the on
screen
>
cursor is next to RETURN TO
MAIN MENU
and pressing SELECT r.
12. If multiroom operation will be used,
the first option enables you to select the
method used for volume control. With the
>
cursor pointing to MULTI RM VOL
press the ‹ or › buttons to choose one of
these options:
VARIABLE: Choose this option if
the volume control in the remote
rooms will be controlled by a remote
control and a sensor connected to the
AVR80 via the MULTI IR input on
the rear panel.
FIXED: Choose this option if there
is no remote control link to the
remote rooms, or if you wish to have
the volume in these rooms remain at
a fixed, constant level.
13. When you have made your selection,
press ¤ q to move to the next option,
SET LEVEL. Press the ‹ or › buttons
q to set the volume in accordance with
the option chosen in the previous menu:
a. If you selected VARIABLE
Volume Set, this option selects the
volume level at the remote rooms
when the system is first turned on in
those locations.
b. If you selected FIXEDVolume
Set, this is the level that will remain
constant in the remote rooms.
INPUT SELECTOR
REC OUT SELECTOR
SURROUND MODE
TEST TONE
MULTI ROOM SEL:OFF
SET UP MENU
MENU OFF
MAIN MENU
Figure 1
CENTER MODE >LARGE
SMALL
NONE
SUB WOOFER ON
OFF
GO TO SET UP MENU 2
RETURN TO MAIN MENU
SET UP MENU 1
Figure 2
MULTI RM VOL
>VARIABLE
FIXED
SET LEVEL XXdB
SET UP LOCK LOCK
UNLOCK
RETURN TO MAIN MENU
SET UP MENU 2
Figure 3
OFF >ON
TEST TONE
Figure 4
AVR80 manual 11/01/98 13:01 Side 17