Filter
Top Products
On Screen Display
27
ENGLISH
The following functions of the AVR80
may be controlled through the Menu
Control System:
INPUT SELECTION: After reaching
the INPUT SELECTORmenu
(Figure #13), use the arrow keys on the
remote q to select the desired input.
Remember that when a split listening
session is desired, select the VIDEO
source first, followed by the AUDIO
source. To use the Tape Monitor, press
the down arrow button ¤ q to move
the on-screen cursor. Use the ‹ and ›
arrow buttons to turn the Tape Monitor
On or Off.
RECORDOUTSELECTION: After
reaching the REC OUT SELECTOR
menu (Figure #14) use the navigational
arrow keys to select the record source for
either TAPE 1or VCR 1. Note that if
the current main input SOURCEis
chosen, two more lines will appear on the
screen to remind you which audio and
video sources are selected (Figure #15).
The RECORDOUTSELECTION
effects the same as the ‘Copy’
Pushbuttons Òon the front panel.
SURROUND MODE: After reaching
the SURROUND MODEmenu (Figure
#16), use the navigational arrows q to
select the desired mode. When a mode is
selected that uses the surround channels,
you may change the rear channel
DELAY TIMEat this menu.
TEST TONE: At this menu you may
adjust the speaker output levels. For
information on this procedure, refer to
the System Configuration section of this
Manual, page 18.
MULTI-ROOM SEL: For information
on configuring and using the multiroom
audio functions of the AVR80, consult the
appropriate section of this Manual, page
32.
SET UP MENU: For information on
using the Set Up menus, refer to the
System Configuration section of this
Manual.
>TAPE *SOURCE*
VCR1 *SOURCE*
AUDIO *TUNER*
VIDEO *LD*
RETURN TO MAIN MENU
REC OUT SELECTOR
Figure 15
>MODE :THX CINEMA
DELAY TIME :20ms
RETURN TO MAIN MENU
SURROUND MODE
Figure 16
AVR80 manual 11/01/98 13:01 Side 27