Filter
Top Products
26
Using the DSP
loudspeakers
Changing the listening position
The balance control of the DSP loudspeakers uses
digital signal processing to compensate for an off-
centre listening position by delaying and diminishing
the sound in one speaker, thus effectively shifting the
speaker’s image back.
The axis control allows you to adjust the optimum
listening height of the DSP loudspeakers, like a
balance control operating in the vertical plane.
If you have a Meridian Surround Controller these
functions are performed via the surround controller.
To change the balance
Press Function < or Function > on the remote
until the display shows the current balance.
For example:
Bal.<0>
Press Function A or Function V to change the
balance.
The display shows the direction and position of the
listening position.
For example:
Bal.12>
There are 32 steps in each direction.
To change the axis
Press Function < or Function > on the remote
until the display shows the current axis setting.
For example:
Axis-1
Press Function A or Function V to change the
axis.
The axis can be adjusted between 3 and -2, where
0 corresponds to the axis of the treble unit. Usually a
•
•
•
•
•
listener will be below that position, so we recommend
settings of -1 or -2.