Filter
Top Products
20
Connecting up the
DSP loudspeakers
Auto configuration
In a system of Meridian products one of the products
acts as the controller for the system. It receives
infra-red commands from the MSR+ and then, if
appropriate, relays them to the other products in the
system via the Comms link.
The following automatic setup procedure should be
used to set up the Comms correctly between several
products:
Switch all the units to standby.
Press Clear on the MSR+ remote.
Each unit will display:
Auto
One unit will then be designated as the controller.
The display shows:
Controller
All the other units will be configured as non-controllers.
The displays show:
Not Con.
If for any reason the automatic setup does not work,
make sure you are operating the remote from a
position where all the units can receive the infra-red,
and try again.
If this fails:
Restore the default operation by selecting one of
the standard types; see
To select a standard setting
,
page 28.
•
•
•
Positioning the digital loudspeakers
For best results adjust the position of the loudspeakers
while listening to music.
If possible, have the most acoustically absorbent wall in
the room behind the front speakers. Ideally have each
DSP loudspeaker at least 0.5m (20") from a corner,
and position them approximately 0.25m (10") from the
wall.
If you are using a DSP loudspeaker as a centre
channel, place the speaker centrally between the main
left-right pair and, if possible, arrange for the treble
units of the three speakers to be approximately the
same height.
You can configure the frequency response of the DSP
loudspeakers to compensate for a position close to a
wall or corner; see
To adjust the frequency response
,
page 32.