Filter
Top Products
TP Receivers • Installation and Operation
Installation and Operation, cont’d
2-10
All models except the TP R 15HD A can be mounted through a
table or podium using an Extron Through-Desk Mounting Kit
for 1/4 or 1/2 Rack Width Products (part #70-077-02). Furniture
mount the receiver as follows:
1. Attach the mounting brackets to the receiver with the
machine screws provided (gure 2-5).
Extron
TP R BNC A
Extron
TP R BNC A
Extron
TP R 15HDA
RGB INPUT
RGB OUTPUT
R
G
BH/HV
V
A
AUDIO
L
R
B
SOG
C SYNC
POWER
15V .5A DC
L R
RGB INPUT
RGB OUTPUT
R
G
B
H/HV V
A
AUDIO
L
R
B
SOG
C SYNC
P
O
W
E
R
15V .5A DC
L R
Through-desk
Mounted
Under-desk
Mounted
Under-desk
Mounted
TP R 15HD A
RGB
PEAKING
LEVEL
Figure 2-5 — Under-desk or through-desk mounting
2. For through-surface mounting (all except TP R 15HD A),
cut the proper sized hole in the mounting surface.
3. Hold the receiver with the attached brackets against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
4. Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked screw
locations.
5. For through-surface mounting (all except TP R 15HD A),
insert four #8 wood screws through the bracket and into
the four pilot holes. Tighten all four screws to secure the
receiver in place.
6. For under-surface mounting, insert #8 wood screws into
the four pilot holes. Tighten each screw into the mounting
surface until slightly less than 1/4" of the screw protrudes.