Filter
Top Products
RGB 201 Rxi Universal Interface • Installation and Operation
2-3
Internal Conguration
The interface is factory congured to output RGBHV or RGBS
video whose sync follows the input and that is clamped to the
back porch. The interface can be congured to output positive
or negative sync, output RsGsBs video, or to clamp on the sync
tip. All of these recongurations require opening the interface’s
case.
1. Remove the three screws on each side and the two screws
on top of the cover (gure 2-1).
Remove (8 )
Screws
RGB 201Rxi
B
O
O
S
T
L
E
V
E
L
C
O
N
T
R
O
L
P
E
A
K
W
IT
H
A
D
S
P
TM
C
E
N
T
E
R
IN
G
Slide cover back slightly,
lift straight up.
Figure 2-1 — Opening the interface
2. Move the cover back slightly to clear the BNC connectors
and then lift it away carefully to avoid straining any cables.
3. Congure the interface as desired. See Sync polarity
jumpers, Internal sync DIP switches (RsGsBs), and Video
clamping jumper in this chapter. Figure 2-2 shows the
location of all of the user-serviceable components.
4. Replace the cover and reinstall the screws.