Filter
Top Products
RGB 201 Rxi Universal Interface • Installation and Operation
Installation and Operation, cont’d
Installation Overview
This is an overview of the installation process. You will nd
detailed installation and operation instructions in this chapter.
To install and set up the RGB 201 Rxi interface, follow these basic
steps:
N
Sync polarity, sync-on-red and sync-on-blue, and video
clamp configuration require opening the interface’s case
and should be done before the interface is mounted.
1
Turn all of the equipment (computers, remote controls,
interface, projector/monitor, local monitor, and speakers
or other audio device) off. Disconnect the power cords
from the power source.
2
If you want the interface to always output positive sync
or negative sync, rather than following the input sync
polarity, open the interface and shift the internal jumpers
as necessary. See Internal Configuration and its subsection,
Sync polarity jumpers, in this chapter.
3
If you want the interface to output RsGsBs video, open the
interface and shift the internal DIP switches as necessary.
See Internal Configuration and its subsection, Internal sync
DIP switches (RsGsBs), in this chapter.
4
If you want the clamp the sync timing of the video output
to the sync tip rather than the back porch, open the
interface and shift the internal jumper as necessary. See
Internal Configuration and its subsection, Video clamping
jumper, in this chapter.
5
Install the rubber feet for tabletop use, or install the
appropriate brackets and furniture or rack mount the
interface. See Mounting the Interface in this chapter.
6
Connect the inputs (computers), output (display, local
monitor, and audio), and remote control. See Rear Panel
Connections and Switches in this chapter.
7
Set the rear panel DIP switches. See Rear Panel Connections
and Switches in this chapter as a guide.
8
Connect power cords and turn on the devices: output
devices (projector, monitors, speakers), remote control
device, interface, and source computers.
9
Adjust horizontal and vertical centering, and also level
and peaking to obtain the best picture.
Installation and Operation
2-2