Filter
Top Products
4
Do Not Move the Unit During Playback
During playback, the disc rotates at high speed. Do NOT lift or
move the unit during playback. Doing so may damage the disc or
the unit.
When Moving This Unit
When changing places of installation or packing the unit for
moving, be sure to remove the disc and return the disc tray to its
closed position in the player. Then, press the power switch to turn
the power off and disconnect the power cord. Moving this unit
with the disc loaded may result in damage to this unit.
Placement of the unit
High-quality hardened tool steel is used for the pin-point feet,
securely attached to the bottom of the unit. Although the outer
feet may appear loose, the weight of the unit causes them to
become firm and secure. The design effectively damps and reduces
vibration.
< To protect the supporting furniture surface, you may stick the felt
pads supplied with the unit to the bottom of the metal feet.
What’s in the box
Please confirm that the following accessories are in the box when you
open it.
Power cord x 1
Remote control unit (RC-1156) x 1
Batteries (AA, R6, SUM-3) x 2
Felt pads x 3
Owner’s manual x 1
Warranty card x 1
Read this before operation
< Place the unit in a stable location near the audio system that you
will use.
< Be careful to avoid injury when moving the unit due to its weight.
Get someone to help you if necessary.
< As the unit may become warm during operation, always leave
sufficient space around the unit for ventilation. Make sure there is
at least 20 cm (8”) of space above and at least 5 cm (2”) of space on
each side of the unit. Do NOT place anything such as a CD, CD-R,
LP, cassette tape etc. on top of the unit.
< The voltage supplied to the unit should match the voltage as
printed on the rear panel. If you are in any doubt regarding this
matter, consult an electrician.
< Choose the installation location of your unit carefully. Avoid placing
it in direct sunlight or close to a source of heat. Also avoid locations
subject to vibrations and excessive dust, heat, cold or moisture.
< Do not open the cabinet as this will void your factory warranty
and might result in damage to the circuitry or electrical shock. If
a foreign object should get into the unit, contact your dealer or
service company.
< When removing the power plug from the wall outlet, always pull
directly on the plug, never yank on the cord.
< Keep this manual in a safe place for future reference.
Before Use
Steel foot
Pin-point foot
Cover foot retaining screwsCover foot
Bottom plate of
the unit