ENGLISH
11
Remote Control Unit
Notes on use
< Point the remote control unit at the main unit’s remote sensor
within seven meters (23 feet) of the main unit. There should not be
any obstacles between the player and the remote control unit.
< Do not allow direct sun or other light to shine on the remote
sensor area of the main unit. This may cause the remote control
unit to work incorrectly.
< Note that other units with remote controls may operate incorrectly
because of infrared light “overspill” when you operate this remote
control unit.
How to insert the batteries
Remove the cover of the remote control unit with a Philips
screwdriver. After checking the polarity (+/_) of two AA batteries,
insert the batteries, replace the cover and replace the screws.
Battery Replacement
If the distance required between the remote control unit and main
unit decreases, the batteries are exhausted. In this case replace the
batteries with new ones.
For more information about collection of batteries, please contact
your local municipality, your waste disposal service or the point of
sale where you purchased the items.
Precautions concerning batteries
< Be sure to insert the batteries with correct positive “+” and negative
“_” polarities.
< Use batteries of the same type. Never use different types of
batteries together.
< Rechargeable or non-rechargeable batteries can be used but not
mixed together. Refer to the precautions on their labels.
< When the remote control unit is not to be used for a long time
(more than a month), remove the batteries from the remote
control unit to prevent them from leaking.
< If the batteries leak, wipe away the liquid inside the battery
compartment and replace the batteries with new ones.
< Do not use any other batteries not specified. Do not mix new
batteries with old ones or use different types of batteries together.
< Do not heat or disassemble batteries and never throw them into
fire or water.
< Do not carry or store batteries with other metallic objects. The
battery may short circuit, leak or explode.
< Never recharge a battery unless it is a verified rechargeable type.
R
GROUP/TITLE (
/
)
The group/ title function cannot be used with this unit.
However, if this button is pressed when playback is stopped,
the source can be selected from CD/SACD and external input.
When external input is selected, it can be used as a D/A converter
(page 17).
S
TRACK/CHAP (.//)
Use these buttons to skip forward or backward during audio
playback (page 14).
T
PAUSE (J)
Use this button to pause playback (page 13).
U
MUTING
When the attenuator function is set to on in the setup mode, this
button temporarily mutes the audio (page 23).
This button is also used for the muting function of Esoteric
amplifiers.